Next
Previous

Wednesday, July 23, 2014

12

CCNA 3 CHAPTER 4 V4.0

Posted in ,
1. Which statement is true when VTP is configured on a switched network that incorporates VLANs?
VTP is only compatible with the 802.1Q standard.
VTP adds to the complexity of managing a switched network.
VTP allows a switch to be configured to belong to more than one VTP domain.
*VTP dynamically communicates VLAN changes to all switches in the same VTP domain.

2. Refer to the exhibit. What information can be learned from the output provided?
It verifies the configured VTP password.
It verifies the VTP domain is configured to use VTP version 2.
*It verifies VTP advertisements are being exchanged.
It verifies the VTP domain name is V1.

Monday, July 21, 2014

0

CCNA 3 CHAPTER 3 V4.0

Posted in ,

1. Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem?
There is a native VLAN mismatch.

The link between Switch1 and Switch2 is up but not trunked.

The router is not properly configured for inter-VLAN routing.

*VLAN 50 is not allowed to entering the trunk between Switch1 and Switch2.


2. Refer to the exhibit. The exhibited configurations do not allow the switches to form a trunk. What is the most likely cause of this problem?

Sunday, July 20, 2014

0

CCNA 3 CHAPTER 2 V4.0

Posted in ,
1. If a network administrator enters these commands on a switch, what will be the result?
Switch1(config-line)# line console 0
Switch1(config-line)# password cisco
Switch1(config-line)# login
to secure the console port with the password “cisco”
to deny access to the console port by specifying 0 lines are available
to gain access to line configuration mode by supplying the required password
*to configure the privilege exec password that will be used for remote access

2. Which command line interface (CLI) mode allows users to configure switch parameters, such as the hostname and password?
user EXEC mode
privileged EXEC mode
*global configuration mode
interface configuration mode

Saturday, July 12, 2014

2

CCNA 3 Chapter 1 V4.0

Posted in ,
1. Which layer of the hierarchical network design model is refered to as the high-speed backbone of the internetwork, where high availability and redundancy are critical?
access layer
*core layer
data-link layer
distribution layer
network layer
physical layer

2. Which two characteristics are associated with enterprise level switches? (Choose two.)
low port density
*high forwarding rate
high latency level
*support link aggregation
predefined number of ports

Wednesday, October 26, 2011

1

CCNA 2 FINAL V4.1

Posted in , , , , ,

1. A company is developing an Internet store for its website. Which protocol should be used to transfer credit card information from customers to the company web server?

FTPS
HTTP
** HTTPS
WEP2
TFTP

2. Refer to the exhibit. A new branch office has been added to the corporate network and a new router is to be installed to allow branch office users to access the database server at headquarters. How should the serial 0/0/0 interface of the new branch office router be configured to connect to the headquarters router?